pn_port_config – CLI command to modify port-config

New in version 2.8.

Synopsis

• This module can be used to modify a port configuration.

Parameters

Parameter	Choices/Defaults	Comments
pn_allowed_tpid string	Choices: vlan q-in-q q-in-q-old	Allowed TPID in addition to 0x8100 on Vlan header.
pn_autoneg boolean	Choices: no yes	physical port autonegotiation.
pn_cliswitch string		Target switch to run the CLI on.
pn_crc_check_enable boolean	Choices: no yes	CRC check on ingress and rewrite on egress.
pn_defer_bringup boolean	Choices: no yes	defer port bringup.
pn_description string		physical port description.
pn_dscp_map string		DSCP map name to enable on port.
pn_edge_switch boolean	Choices: no yes	physical port edge switch.
pn_egress_rate_limit string		max egress port data rate limit.
pn_enable boolean	Choices: no yes	physical port enable.
pn_eth_mode -	Choices: 1000base-x sgmii disabled GMII	physical Ethernet mode.
pn_fabric_guard boolean	Choices: no yes	Fabric guard configuration.
pn_host_enable boolean	Choices: no yes	Host facing port control setting.
pn_intf string		physical interface.
pn_jumbo boolean	Choices: no yes	jumbo frames on physical port.
pn_lacp_priority string		LACP priority from 1 to 65535.
pn_local_switching boolean	Choices: no yes	no-local-switching port cannot bridge traffic to another no-local-switching port.
pn_loop_vlans string		looping vlans.
pn_loopback boolean	Choices: no yes	physical port loopback.
pn_mirror_only boolean	Choices: no yes	physical port mirror only.
pn_pause boolean	Choices: no yes	physical port pause.
pn_port string		physical port.
pn_port_mac_address string		physical port MAC Address.
pn_reflect boolean	Choices: no yes	physical port reflection.
pn_routing boolean	Choices: no yes	routing.
pn_send_port string		send port.
pn_speed -	Choices: disable 10m 100m 1g 2.5g 10g 25g 40g 50g 100g	physical port speed.
pn_vxlan_termination boolean	Choices: no yes	physical port vxlan termination setting.
state string / required	Choices: update	State the action to perform. Use update to modify the port-config.

Examples

- name: port config modify
  pn_port_config:
    pn_cliswitch: "sw01"
    state: "update"
    pn_port: "all"
    pn_dscp_map: "foo"

- name: port config modify
  pn_port_config:
    pn_cliswitch: "sw01"
    state: "update"
    pn_port: "all"
    pn_host_enable: true

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
changed boolean	always	indicates whether the CLI caused changes on the target.
command string	always	the CLI command run on the target node.
stderr list	on error	set of error responses from the port-config command.
stdout list	always	set of responses from the port-config command.

Status

• This module is not guaranteed to have a backwards compatible interface. [preview]

• This module is maintained by the Ansible Community. [community]

Authors

• Pluribus Networks (@rajaspachipulusu17)

Hint

If you notice any issues in this documentation, you can edit this document to improve it.